Tech SkillsGoal and Loop Commands

Goal vs Loop Question Explained

This worked Loop Engineering practice question tests Goal and Loop Commands. Try the answer first, then review why C is the best choice.

Short answer

The correct answer is C. Use /goal for the five changes, then /loop to watch for new tasks.

A /goal sets a completion condition and Claude keeps working toward it until an evaluator judges it met. That fits a defined job you want finished now. A /loop runs a prompt on a schedule while the session stays open. That fits checking back for new work that does not exist yet. The correct answer is C. Use /goal for the five changes, then /loop to watch for new tasks

The Question

You have five page changes that must be finished and confirmed before lunch. After lunch you want Claude to keep picking up new tasks you add during the afternoon. Which plan fits?

AUse /loop for the five changes and /goal for the afternoon
BUse /goal for both, restating the goal each time you add an afternoon task
CUse /goal for the five changes, then /loop to watch for new tasksCorrect
DUse /loop for both, with a one-minute interval all day

Why C is correct

A /goal sets a completion condition and Claude keeps working toward it until an evaluator judges it met. That fits a defined job you want finished now. A /loop runs a prompt on a schedule while the session stays open. That fits checking back for new work that does not exist yet. The correct answer is C. Use /goal for the five changes, then /loop to watch for new tasks

Why the other options are wrong

Option A: Use /loop for the five changes and /goal for the afternoon

This is backwards. A goal ends once its condition is met, so it cannot keep watching for afternoon tasks. The five known changes are the job with a clear end.

Option B: Use /goal for both, restating the goal each time you add an afternoon task

Restating a goal for each new task is manual work the loop would do for you, and a cleared goal does not wait for anything.

Option D: Use /loop for both, with a one-minute interval all day

A one-minute loop can finish the five changes, but no separate check confirms the morning job is done. /goal adds an evaluator that checks the condition after every turn.

Key idea: Goal and Loop Commands

Loop engineering is a practice skill. Open Claude Code in a throwaway folder, write one small task in a file, and run it with /loop or /goal while you watch. If you doubt an answer, test it against a real run in that folder.

Ready to test the full skill?

Take the free Loop Engineering quiz and find the exact basics to review next. No signup required.

Practice related questions

Same skill area or adjacent concept. Use these after reviewing the explanation.

Related Loop Engineering Practice Questions